Page 5
Installation
Installing the
Mini MAU
To install a recessed Asanté Mini MAU in a double-slotted module,
do the following:
1
Unscrew the two ejector screws on each side of the mod-
ule’s front panel and pull out the module approximately
four-to-five inches from the chassis.
2
Remove the Mini MAU’s filler plate.
3
Insert the Mini MAU by hand-guiding it into its recessed
slot until the MAU is securely fastened to its connector.
4
Re-insert the module into the chassis.
Installing the
10BaseF Module
This installation assumes that you have already installed the 2072
chassis.
To install the 10BaseF Module, do the following steps:
1
Make sure the hub is turned on. Having the power already
turned on allows the LEDs on the module to immediately
light during installation.
2
Observing the antistatic procedures, remove the module
from its antistatic packaging.
❖
Note: Handle the module only by its edges. Do not touch
chips or connectors.
❖
3
Align the module to the edges of the card guides to any
available slot in the chassis. Gently slide the module in until
you can begin tightening the screws. SeeFigure 2 on
Page 6.
❖
Important:
Do not force the module into a slot. Forcing
the module into a slot can damage the backplane.
❖
Comments to this Manuals