Asante 2072 Installation Guide download pdf (Page 17)

Page 16

AsantéHub 2072 Network Management Module Installation Guide

The fourth conﬁguration connects a terminal to an individual hub

using the RS232 connector as a local management port. The ﬁfth

conﬁguration connects an AMS to a single hub using one of the

hub’s AMS Link ports and an AMS Link Extender.

Figure 7 DIP switch settings for Local Management Port, and AMS

Link Extender with single hub

Connecting a Modem to

the Hub

For remote management purposes, you can make a local connec-

tion from the RS232 serial port on the NMM to a modem. You can

use this setup with AsantéView and the AsantéView Management

Station (AMS) to activate a pager when it receives a trap message

from a hub. This trap message causes the AMS to page this event to

the remote user. See the appropriate AsantéView User’s Guide for

information on setting up trap messages and paging options.



Straight-through RS232

Configuration 4

Configuration 5

Out-of-Band single hub

Local management port

AMS

only this device

is managed

Ethernet backbone

AMS Link Extender

Terminal

Hub Hub Hub Hub

Hub

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

No comments

Asante 2072 Installation Guide Page 17