Asante 2072 Installation Guide download pdf (Page 22)

Page 21

Using Telnet

Using Telnet You can use Telnet to interrogate and program an AH2072 NMM

NMM with a NetStacker hub or AsantéHub

2072. You can do this

using any Telnet-capable computer, either directly connected to

the hub or over the network.

∆ Information on installing Telnet is not provided in

this manual. Refer to the documentation that

comes with the Telnet software.

The following list is a summary of the steps you need to perform

to use Telnet with an AH

2072 NMM connected to a NetStacker

hub or an AsantéHub

2072.

❏ Install the image code on the AMS

❏ Upgrade the hub’s image code

❏ Establish a link with the hub using Telnet

This procedure assumes you‘ve already done the following:

❏ Installed AsantéView In-Band or Out-of-Band soft-

ware on the AMS

❏ Connected appropriate cables for In-Band or

Out-of-Band management

❏ Set hub DIP Switches if needed

❏ Assigned an IP address to the hub

❏ Installed the Telnet application on your network

management station

Refer to the Telnet software documentation for installation

instructions. See the appropriate AsantéView User’s Guide for

information on installing and conﬁguring the appropriate soft-

ware and hardware for using AsantéView.

Installing the Image Code Before you upgrade the image code in the AH2072 NMM with a

NetStacker hub or AsantéHub

2072, you need to install the image

code ﬁles on the AMS. Table 3 lists the ﬁles you need.

Table 3 Image Code File Names

AsantéHub 2072

2072huxx.17x or higher

2072h.cfg

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 45 46

No comments

Asante 2072 Installation Guide Page 22