Page 10
Installing the NetStacker Chassis
Building a Stack of
NetStacker Hubs
You can build a stack of two or three NetStacker hubs.
The first hub in a stack must be the Base Hub while the second and
third hubs (called Expansion hubs ) must be used only with a Base
Hub.
∆ Note: If you plan to mount the stack on a rack, fol-
low the instructions on page 12.
To build a stack of two or three NetStacker Hubs:
1
Place the Base Hub on a flat surface.
The Base Hub consists of a base chassis containing
one or two modules.
2
Remove the label covering the connector in the upper
right corner of the Base Hub.
3
Holding the Expansion Hub with both hands, lower
the hub straight down on top of the Base Hub.
4
When you have lined up the bus extension connectors
at the right corners of the hubs, press down lightly on
the top of the Expansion Hub until the edge connec-
tor at the rear of the unit is fully inserted.
5
If you are adding a second Expansion Hub, repeat
steps 2 and 3, mounting the second Expansion Hub on
top of the first Expansion Hub.
The maximum number of Expansion Hubs is two.
Figure 5 shows a second Expansion Hub being stacked on top of
an Expansion Hub.
Comments to this Manuals