Asante Desktop EN/SC User Manual

IntraCore™ 3524 Series Gigabit Ethernet Switches Getting Started Guide

10 Getting Started Guide •Do not tamper with the internal components of your switch. This could void your warranty •Examine your work area for potenti

11 Asanté IntraCore 3524 Failure to observe these limits may cause damage to the switch and void the warranty. Avoid direct sunlight, heat sources, o

12 Getting Started Guide To mount the switch onto an equipment rack: 1. Place the switch on a flat, stable surface. 2. Locate a rack-mounting bracket

13 Asanté IntraCore 3524 2. Place the unit on a flat surface with a minimum area of 434.3 mm x 342.9 mm (17.1” x 13.5”) and support capacity of 10 kg

14 Getting Started Guide 2.8.3 GBIC Care and Handling Follow these GBIC maintenance guidelines: •Unnecessary removal and insertion of a GBIC can lea

15 Asanté IntraCore 3524 2.10 Connecting Power Use the following procedure to connect power to the switch: Important! Carefully review the power req

16 Getting Started Guide Note: There is no uplink port on this switch. All 10/100 ports on this switch are auto-sensing MDI/MDI-X. This advanced featu

17 Asanté IntraCore 3524 2.11.2 Gigabit Ethernet Ports Cabling Procedures Cabling requirements for the Gigabit Ethernet modules depend on the type of

18 Getting Started Guide • All stacked units are managed through connection to the master switch, via console, telnet or web interfaces Note: W

19 Asanté IntraCore 3524 console connection to the first unit. Type k in the Configuration Menu to access the Stacking Management menu, shown be-low.

2 Getting Started Guide Quick Start Guide Follow these steps to install your IntraCore switch: 1. Open the box and check the contents. See Chapter 1

20 Getting Started Guide 4. After all units have had stacking enabled, connect the console to the first unit (the Master unit). 5. Power cycle the who

21 Asanté IntraCore 3524 Appendix A Troubleshooting In the unlikely event your network does not operate properly, follow the troubleshooting tips bel

22 Getting Started Guide

23 Asanté IntraCore 3524 Appendix B Safety and Regulatory Com-pliance FCC Compliance Statement This equipment has been tested and found to comply wi

24 Getting Started Guide

25 Asanté IntraCore 3524 Appendix C Features and Specifications The IntraCore 3524 Series is Asanté’s most powerful, flexible work-group switch. See

26 Getting Started Guide

27 Asanté IntraCore 3524 Appendix D Serial Port Pin Outs The console port is used to connect with a terminal using a DB-9 female connector. The setti

28 Getting Started Guide

29 Asanté IntraCore 3524 Appendix E Warranty and Support The IntraCore switch is covered by Asanté’s 3-year IntraCare™ product warranty and advanced

3 Asanté IntraCore 3524 Table of Contents Quick Start Guide 2 1. Introduction

30 Getting Started Guide

31 Asanté IntraCore 3524

32 Getting Started Guide IntraCore 3524 Series Gigabit Ethernet Switches Getting Started Guide Asanté Technologies, Inc. 821 Fox Lane San

4 Getting Started Guide

5 Asanté IntraCore 3524 1 Introduction The IntraCore 3524 Series Thank you for purchasing the Asanté IntraCore 3524 Series Gigabit switch. The Intra

6 Getting Started Guide The system can operate as a stand-alone network or be used in combination with other IntraCore series switches in the backbone

7 Asanté IntraCore 3524 Port # LED Color Description 25,26 Gigabit (speed) Solid Green Off A valid 1000Mbps link has been established No link ha

8 Getting Started Guide 1.3 Front Panel Description From left to right, the front panel contains the following: Power and port LEDs; 24 10/100 ports;

9 Asanté IntraCore 3524 2 Installation and Setup This chapter explains how to install and connect the switch to your network. To configure the switch