Asante NetStacker Hub User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
Installation
Page 2-8
2 Make sure that the length of the straight through cable
between the NetStacker II and a 100Mbps repeater does not
exceed 5 meters, including all patch cables and cross con-
nect wires. The cable between the NetStacker II and any
switch or any 10Mbps repeater cannot exceed 100 meters.
Note: If you need to connect more than 2 hubs via
100Mbps connections, you must have a switch separat-
ing the additional hubs.
3 Connect one end of the cable to the selected RJ-45 port of
the NetStacker II hub.
4 Connect the other end of the cable to the selected RJ-45
port of the other hub. A connection from the Uplink Port
(Port 12) to a non-uplink Port on another hub is shown in
Figure 2-9.
5 Press the Uplink button in if your connection type and
cable require it. See Table 2-1 for Uplink button settings.
Table 2-1 Connecting cables and uplink button settings
Connecting: Cable Uplink Button
From Uplink Port (Port 12)
To non-uplink port
Straight through Press in
From Uplink Port (Port 12)
To non-uplink port
Cross-over Do not press in
From Uplink Port (Port 12)
To Uplink Port on other hub
Straight through Press in ONE, not
both
From Uplink Port (Port 12)
To Uplink Port on other hub
Cross-over Do not press in
either button
From non-uplink Port
To non-uplink Port
Cross-over ONLY Do not press in
From non-uplink Port
To Uplink Port on other hub
Straight through Press in button on
OTHER hub
From non-uplink Port
To Uplink Port on other hub
Cross-over Do not press in
either button
SHBBook Page 8 Wednesday, March 3, 1999 8:03 PM
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Comments to this Manuals

No comments