Asante IntraCore 65120 Series User Manual

IntraCore™ 65120 Series Gigabit Ethernet Switches Getting Started Guide

10 Getting Started Guide • Do not tamper with the equipment • Examine your work area for potential hazards (I.e. wet floors, ungrounded cables, etc.)

11 Asanté IntraCore 65120 Avoid direct sunlight, heat sources, or areas with high levels of electromagnetic interference. 2.5 Cooling and Airflow Th

12 Getting Started Guide To mount the IntraCore 65120 in an equipment rack: 1. Place the IntraCore 65120 on a flat, stable surface. 2. Locate a rack-

13 Asanté IntraCore 65120 2. Place the unit on a flat surface with a minimum area of 434.3 mm x 342.9 mm (17.1” x 13.5”) and support capacity of 10 kg

14 Getting Started Guide 3. Slide the GBIC out of the slot. 4. Install the plugs in the GBIC optical bores, and place the GBIC in protective packaging

15 Asanté IntraCore 65120 2.10 Connecting to the Network The IntraCore 65120 unit may be connected to an Ethernet network with the unit powered on or

16 Getting Started Guide Although 10BaseT requires only pins 1, 2, 3 and 6, Asanté strongly recommends cables with all 8 wires connected as follows:

17 Asanté IntraCore 65120 The console port is used to connect with a terminal using a DB-9 female connector. The setting is 9600-N81. See Table 2-2 fo

18 Getting Started Guide

19 Asanté IntraCore 65120 Appendix A Troubleshooting and Online Registration In the unlikely event your network does not operate properly, follow the

2 Getting Started Guide Quick Start Guide Follow these steps to install the IntraCore 65120 switch: 1. Open the box and check the contents. See Chap

20 Getting Started Guide

21 Asanté IntraCore 65120 Appendix B Safety and Regulatory Compliance FCC Compliance Statement NOTE: This equipment has been tested and found to co

22 Getting Started Guide

23 Asanté IntraCore 65120 Appendix C Defaults and Specifications The IntraCore 65120 is shipped with the following factory default settings and speci

24 Getting Started Guide 65120 Series Gigabit Ethernet Switches Getting Started Guide Asanté Technologies, Inc. 821 Fox Lane San Jose, CA

3 Asanté IntraCore 65120 Table of Contents Quick Start Guide 2 1. Introduction

4 Getting Started Guide

5 Asanté IntraCore 65120 1 Introduction The IntraCore 65120 Thank you for purchasing the Asanté IntraCore 65120 Gigabit switch. The IntraCore 65120

6 Getting Started Guide 1.2 LEDs After the power is turned on, the power LED will cycle through from amber, to off (for system initialization), to am

7 Asanté IntraCore 65120 1.3 Front Panel Description The 65120-2G (Figure 1-1) has ten 10/100/1000 copper ports, 2 GBIC ports and a console port. T

8 Getting Started Guide

9 Asanté IntraCore 65120 2 Installation and Setup This chapter explains how to install and connect the IntraCore 65120 to your network. To configure