Asante 10T Hub/24 Specifications download pdf (Page 158)

158

Connecting 9-GB MediaDrives

The following procedure applies when connecting Þxed and

removable drive chassis to a system.

Failure to install storage devices correctly can prevent the system

from starting or operating successfully. Use only Avid-supplied

cables for optimal performance.

Use up to seven drives. A chassis includes two drives.

1. Use a 68- to 68-pin single-ended SCSI cable to attach a MediaDrive

to the Avid Media Processor:

a. Plug one end of the cable into a single-ended SCSI connector

on the Avid Media Processor.

b. Plug the other end of the cable into one of the single-ended

SCSI connectors on the back of the MediaDrive.

Or to connect a chassis, use an ATTO-to-chassis cable:

a. Plug one end of the cable into a single-ended SCSI connector

on the Avid Media Processor.

b. Plug the other end of the cable into one of the single-ended

SCSI connectors on the back of the chassis.

2. Attach the remaining devices using a SCSI-to-SCSI cable between

drives, a SCSI-to-Chassis cable to connect a MediaDrive to a

chassis, and a Chassis-to-Chassis cable between chassis.

3. Set the SCSI ID on each drive to a unique number from 0-6,

inclusive.

4. Terminate only the last drive in the chain using a purple or blue

active MediaDrive or chassis terminator (see Figure 9-8).

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 301 302

No comments

Asante 10T Hub/24 Specifications Page 158