12
Setup Guide
•
Do not tamper with the internal components of the switch. This
could void the product’s warranty
•
Examine the work area for potential hazards (such as wet
floors or ungrounded cables) and eliminate them before install-
ing the switch
For more safety information, please refer to the User’s Manual.
2.2 Recommended Installation Tools
The following tools and equipment (not included)
are needed to install the switch:
• Flat head screwdriver
• Phillips head screwdriver
• Antistatic mat or foam
2.3 Power Requirements
The electrical outlet should be located near the switch and be easily
accessible. It must also be properly grounded.
Make sure the power source adheres to the following guidelines:
•
Power: Auto-switching 90-260 VAC
•
Frequency range: 50/60 Hz
2.4 Environmental Requirements
The switch must be installed in a clean, dry, dust-free area
with adequate air circulation to maintain the following environ-
mental limits:
•
Operating Temperature: 0° to 40° C (32° to 104° F)
•
Relative Humidity: 10% to 90% non-condensing
Comments to this Manuals