Asante IntraCore 35516 Series Setup Guide download pdf (Page 14)

Setup Guide

To mount the switch onto an equipment rack:

1. Place the switch on a flat, stable surface.

2. Locate a rack-mounting bracket (supplied) and place it over the

mounting holes on one side of the unit.

3. Use the screws (supplied) to secure the bracket (with a Phillips

screwdriver).

4. Repeat the two previous steps

on the other side of the unit.

5. Place the switch in the equip-

ment rack.

6. Secure the switch by securing

its mounting brackets onto the

equipment rack.

Important! Make sure the unit is

supported until all of the mounting screws for each bracket are se-

cured to the equipment rack. Failure to do so could cause the unit to

fall, which may result in personal injury or damage to the unit.

2.7.2 Equipment Rack Guidelines

•

Size: 17.1 x 10.1 x 1.6 inches (IC35516-T)

17.5 x 14.0 x 2.6 inches (IC35516-G)

•

Ventilation: Ensure that the rack is installed in a room in

which the temperature remains below 40° C (104° F). Be sure

that no obstructions, such as other equipment or cables,

block airflow to or from the vents.

•

Clearance: In addition to providing clearance for ventilation, ensure

that adequate clearance for servicing the switch from the front ex-

ists.

2.7.3 Free-Standing/Desktop Placement

The switch has rubber feet for the bottom of the case that allow for se-

cure, free-standing placement of the unit.

Follow the steps below for free-standing/desktop placement:

1. Attach the rubber pads (supplied) to the bottom of each corner of

the unit.

2. Place the unit on a flat, stable surface.

3. Make sure enough ventilation space between the switch and sur-

rounding walls or objects exists.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Asante IntraCore 35516 Series Setup Guide Page 14