Asante IntraCore 35516 Series Setup Guide download pdf (Page 17)

Asanté IntraCore 35516 Series Switches

2.10 Connecting Power

Important! Carefully review the power requirements (Chapter 2.3)

before connecting power to the unit.

Use the following procedure to connect power to the switch:

1. Plug one end of the supplied power cord into the power con-

nector on the back of the unit.

2. Plug the other end into a grounded AC outlet. The power LED

will begin its initialization process.

The front panel LEDs blink and the power LED illuminates when it

has initialized. The switch is ready for connection to the network.

Important:

If the power does not come on, refer to Appendix A

Troubleshooting.

2.11 Connecting to the Network

The switch may be connected to an Ethernet network with the unit

powered on or off.

Use the following procedure to make your net-

work connections:

1. Connect network devices to the switch, using the cable guide-

lines that follow.

2. After the unit is connected to the network, it can be configured

for management capabilities. Please refer to the User’s Manual

on the CD-ROM for instructions on how to set up the manage-

ment features of the switch.

2.11.1 10/100/1000BaseTX Ports Cabling Procedures

The 10/100/1000 ports on the switch allow for the connection of

10BaseT, 100BaseTX, or 1000BaseT net-

work devices. The ports are compatible with

IEEE 802.3 and 802.3u standards.

Important: The switch must be located

within 100 meters of its attached devices.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Asante IntraCore 35516 Series Setup Guide Page 17