Asante IntraCore 36000 Series User Manual download pdf (Page 164)

164 Asanté IntraCore 36000 Series

map access-list mac Sets the CoS value and corresponding output queue for packets

matching an ACL rule

show map access-list

mac

Shows CoS value mapped to an access list for an interface PE

match access-list mac Changes the 802.1p priority the priority of a frame matching the

defined rule (For example, also called packet marking)

show marking Displays the current configuration for packet marking PE

15.5.3 ACL Information

The following table lists the commands used to show information about ACLs.

Command Function Mode

show access-list Show all ACLs and associated rules PE

show access-group Shows the ACLs assigned to each port PE

15.6 SNMP Commands

Controls access to this switch from management stations using the Simple Network Management Protocol

(SNMP), as well as the error types sent to trap managers.

Command Function Mode

snmp-server community Sets up the community access string to permit access to SNMP

commands

snmp-server contact Sets the system contact string GC

snmp-server location Sets the system location string GC

snmp-server host Specifies the recipient of an SNMP notification operation GC

snmp-server enable traps Enables the device to send SNMP traps (For example, SNMP

notifications)

show snmp Displays the status of SNMP communications NE, PE

15.7 DHCP Commands

These commands are used to configure Dynamic Host Configuration Protocol (DHCP) client. You can

configure any VLAN interface to be automatically assigned an IP address via DHCP.

DHCP Client

Command Function Mode

ip dhcp restart Submits a BOOTP or DHCP client request PE

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 384 385

No comments

Asante IntraCore 36000 Series User Manual Page 164