Asante IntraCore 36000 Series User Manual download pdf (Page 166)

166 Asanté IntraCore 36000 Series

shutdown Disables an interface IC

switchport broadcast

packet-rate

Configures the broadcast storm control threshold IC

clear counters Clears statistics on an interface PE

show interfaces status Displays status for the specified interface NE, PE

show interfaces counters Displays statistics for the specified interfaces NE, PE

show interfaces

switchport

Displays the administrative and operational status of an interface NE, PE

15.9 Mirror Port Commands

This section describes how to mirror traffic from a source port to a target port.

Command Function Mode

port monitor Configures a mirror session IC

show port monitor Shows the configuration for a mirror port PE

15.10 Rate Limit Commands

This function allows the network manager to control the maximum rate for traffic transmitted or received on

an interface. Rate limiting is configured on interfaces at the edge of a network to limit traffic into or out of the

network. Traffic that falls within the rate limit is transmitted, while packets that exceed the acceptable

amount of traffic are dropped.

Rate limiting can be applied to individual ports or trunks. When an interface is configured with this feature,

the traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped,

conforming traffic is forwarded without any changes.

Command Function Mode

rate-limit Configures the maximum input or output rate for a port IC

15.11 Link Aggregation Commands

Ports can be statically grouped into an aggregate link (For example, trunk) to increase the bandwidth of a

network connection or to ensure fault recovery. You can use the Link Aggregation Control Protocol (LACP)

to automatically negotiate a trunk link between this switch and another network device. For static trunks, the

switches have to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches have to

comply with LACP. This switch supports up to six trunks. For example, a trunk consisting of two 1000 Mbps

ports can support an aggregate bandwidth of 4 Gbps when operating at full duplex.

The following table lists the manual configuration commands.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 384 385

No comments

Asante IntraCore 36000 Series User Manual Page 166