86 Asanté IntraCore 36000 Series
Field Attributes (CLI)
Basic information
Port type – Indicates the port type. (1000BASE-T, 1000BASE-SX, 1000BASE-LX or 1000BASE-LH)
MAC address – The physical layer address for this port. (To access this item on the web, see section 2.4
Setting an IP Address.)
Configuration
Name – Interface label.
Port admin – Shows if the interface is enabled or disabled (For example, up or down).
Speed-duplex – Shows the current speed and duplex mode. (Auto, or fixed choice)
Capabilities – Specifies the capabilities to be advertised for a port during auto-negotiation. (To access this
item on the web, see section 7.2 Configuring Interface Connections.) The following capabilities are
supported.
• 10half - Supports 10 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
• 100full - Supports 100 Mbps full-duplex operation
• 1000full - Supports 1000 Mbps full-duplex operation
• Sym - Transmits and receives pause frames for flow control
• FC - Supports flow control
Broadcast storm – Shows if broadcast storm control is enabled or disabled.
Broadcast storm limit – Shows the broadcast storm threshold. (500 - 262143 packets per second)
Flow control – Shows if flow control is enabled or disabled.
LACP – Shows if LACP is enabled or disabled.
Port Security – Shows if port security is enabled or disabled.
Max MAC count – Shows the maximum number of MAC address that can be learned by a port. (0 - 20
addresses)
Port security action – Shows the response to take when a security violation is detected. (shutdown, trap,
trap-and-shutdown)
Combo forced mode – Shows the forced/preferred port type to use for combination ports 21-24 or 45-48.
(copper forced, copper preferred auto, SFP forced, SFP preferred auto)
Current status
Link Status – Indicates if the link is up or down.
Comments to this Manuals